D-Link DGS-3312SR, Справочное руководство по интерфейсу командной строки

Страница: 99 / 305

DGS-3312SR Layer 3 Gigabit Switch
93
show bandwidth_control
Purpose Used to display the bandwidth control configuration on the switch.
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command displays the current
bandwidth control configuration on the switch, on a port-by-port
basis.
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4
−
in numerical order.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the switch stack.
Restrictions None.
Example usage:
To display bandwidth control settings:
DGS-3312SR:4#show bandwidth_control 1:1-1:10
Command: show bandwidth_control 1:1-1:10
Bandwidth Control Table
Port RX Rate (Mbit/sec) TX_RATE (Mbit/sec)
---- ------------------------ ----------------------
1:1 no_limit 10
1:2 no_limit 10
1:3 no_limit 10
1:4 no_limit 10
1:5 no_limit 10
1:6 no_limit 10
1:7 no_limit 10
1:8 no_limit 10
1:9 no_limit 10
1:10 no_limit 10
DGS-3312SR:4#
config 802.1p user_priority
Purpose Used to map the 802.1p user priority tags of an incoming packet
to one of the eight hardware queues available on the switch.
Syntax
config 802.1p user_priority <priority 0-7> <class_id 0-7>
Description
The config 802.1p user_priority command is used to configure
the way the switch will map an incoming packet, based on its
802.1p user priority tag, to one of the eight hardware priority