D-Link DGS-3312SR, Справочное руководство по интерфейсу командной строки

Страница: 231 / 305

DGS-3312SR Layer 3 Gigabit Switch
225
config vrrp ipif authtype
Purpose To configure the authentication type for a VRRP entry.
Syntax config vrrp ipif authtype <ipif_name 12> [none | simple authdata
<string 8> | ip authdata <string 16>]
Description This command is used to set the authentication type for a VRRP
entry on the switch.
Parameters <ipif_name 12> - Enter the name of a previously configured IP
interface that you wish to configure the VRRP entry for. This IP
interface must be assigned to a VLAN on the switch.
authtype – Specifies the type of authentication used. The authtype
must be consistent with all routers participating within the VRRP
group. The user may choose between:
none – Entering this parameter indicates that VRRP protocol
exchanges will not be authenticated.
simple authdata <string 8> - This parameter, along with an
alphanumeric string of no more than eight characters, to set
a simple password for comparing VRRP message packets
received by a router. If the two passwords are not exactly
the same, the packet will be dropped.
ip authdata <string 16> - This parameter will require the user
to set an alphanumeric authentication string of no more than
16 characters to generate a MD5 message digest for
authentication in comparing VRRP messages received by
the router. If the two values are inconsistent, the packet will
be dropped.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the authentication type for a VRRP entry:
DGS-3312SR:4#config vrrp ipif Trinity authtype simple authdata tomato
Command: config vrrp ipif Trinity authtype simple authdata tomato
Success.
DGS-3312SR:4#