D-Link DGS-3312SR, Справочное руководство по интерфейсу командной строки

Страница: 187 / 305

DGS-3312SR Layer 3 Gigabit Switch
181
DGS-3312SR:4#config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Command: config 802.1x auth_parameter ports 1:1-1:20 direction both
Success.
DGS-3312SR:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax config 802.1x init [port_based ports [<portlist | all>] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr}]
Description The config 802.1x init command is used to immediately initialize
the 802.1x functions on a specified range of ports or for specified
MAC addresses operating from a specified range of ports.
Parameters port_based – This instructs the switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization
can then be specified.
<portlist>
−
Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4
−
in
numerical order.
all
−
Specifies all of the ports on the switch.
mac_based - This instructs the switch to initialize 802.1x functions
based on the MAC address of a device on a specific port or range
of ports. MAC address approved for initialization can then be
specified.
<portlist>
−
Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4
−
in
numerical order.
all
−
Specifies all of the ports on the switch.
mac_address <macaddr> - Specifies the MAC address of the
client the user wishes to add.
Restrictions Only administrator-level users can issue this command.