DGS-3312SR Layer 3 Gigabit Switch
276
DGS-3312SR:4#config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Command: config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Success.
DGS-3312SR:4#
config ospf all
Purpose
Used to configure all of the OSPF interfaces on the switch at one time.
Syntax
config ospf all {area <area_id> | priority <value> | hello_interval
<sec 1-65535> | dead_interval <sec 1-65535> | authentication
[none | simple <password 8> | md5 <key_id 1-255>] | metric
<value 1-65535> | state [enable | disable]}
Description
This command is used to configure all of the OSPF interfaces on the
switch, using a single group of parameters, at one time.
Parameters
area <area_id>
- A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
priority <value>
−
The priority used in the election of the Designated
Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535>
−
Allows the specification of the interval
between the transmission of OSPF Hello packets, in seconds.
Between 1 and 65535 seconds can be specified. The Hello Interval,
Dead Interval, Authorization Type, and Authorization Key should be
the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the length
of time between the receipt of Hello packets from a neighbor router
before the selected area declares that router down. An interval
between 1 and 65535 seconds can be specified. The Dead Interval
must be evenly divisible by the Hello Interval.
metric <value 1-65535 >
−
The interface metric (1 to 65535). Entering
a 0 will allow automatic calculation of the metric.
authentication
– Enter the type of authentication preferred. The user
may choose between:
none
– Choosing this parameter will require no authentication.
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive password
of no more than 8 characters.
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
metric <value 1-65535>
−
This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable]
– Used to enable or disable this function.
Restrictions Only
administrator-level users can issue this command.
Usage Example
Содержание DGS-3312SR
Страница 2: ......
Страница 4: ......
Страница 57: ...DGS 3312SR Layer 3 Gigabit Switch 51 DGS 3312SR 4 disable rmon Command disable rmon Success DGS 3312SR 4...
Страница 305: ...DGS 3312SR Layer 3 Gigabit Switch 3 www dlink co uk...