DGS-3312SR Layer 3 Gigabit Switch
180
config 802.1x auth_parameter
Parameters
<portlist>
−
Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2,
port 4
−
in numerical order.
all
−
Specifies all of the ports on the switch.
default
−
Returns all of the ports in the specified range to their
802.1x default settings.
direction [both | in]
−
Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control
−
Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
•
force_auth
−
Forces the Authenticator for the port to
become authorized. Network access is allowed.
•
auto
−
Allows the port’s status to reflect the outcome of
the authentication process.
•
force_unauth
−
Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535>
−
Configures the time interval
between authentication failure and the start of a new
authentication attempt.
tx_period <sec 1-65535>
−
Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>
−
Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for
the Request/Identity packets.
server_timeout <sec 1-65535>
−
Configure the length of time to
wait for a response from a RADIUS server.
max_req <value 1-10>
−
Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535>
−
Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable]
−
Determines whether or not the
switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
Содержание DGS-3312SR
Страница 2: ......
Страница 4: ......
Страница 57: ...DGS 3312SR Layer 3 Gigabit Switch 51 DGS 3312SR 4 disable rmon Command disable rmon Success DGS 3312SR 4...
Страница 305: ...DGS 3312SR Layer 3 Gigabit Switch 3 www dlink co uk...