D-Link DGS-3312SR, Справочное руководство по интерфейсу командной строки

Страница: 281 / 305

DGS-3312SR Layer 3 Gigabit Switch
275
config ospf ipif
Purpose Used to configure the OSPF interface settings.
Syntax
config ospf ipif <ipif_name 12> {area <area_id> | priority
<value> | hello_interval <sec 1-65535>| dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5
<key_id 1-255>] | metric <value 1-65535> | state [enable |
disable]}
Description This command is used to configure the OSPF interface settings.
Parameters
<ipif_name 12>
−
The name of the IP interface.
area <area_id> - A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
priority <value>
−
The priority used in the election of the
Designated Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535>
−
Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The
dead
interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 >
−
The interface metric (1 to 65535).
Entering a 0 will allow automatic calculation of the metric.
authentication – Enter the type of authentication preferred. The
user may choose between:
none – Choosing this parameter will require no
authentication.
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive
password of no more than 8 characters.
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
metric <value 1-65535>
−
This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable] – Used to enable or disable this function.
Restrictions Only administrator-level users can issue this command.
Usage Example
To configure OSPF interface settings: