D-Link DGS-3312SR, Справочное руководство по интерфейсу командной строки

Страница: 284 / 305

DGS-3312SR Layer 3 Gigabit Switch
278
Interface Name: ipif2 IP Address: 123.234.12.34/24 ((Link Up)
Network Medium Type: BROADCAST Metric: 1
Area ID: 1.0.0.0 Administrative State: Enabled
Priority: 1 DR State: DR
DR Address: 123.234.12.34 Backup DR Address: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Authentication: None
Total Entries: 2
DGS-3312SR:4#
create ospf virtual_link
Purpose Used to create an OSPF virtual interface.
Syntax create ospf virtual_link <area_id> <neighbor_id> {hello_interval
<sec 1-65535> | dead_interval <sec 1-65535> | authentication
[none | simple <password 8> | md5 <key_id 1-255>]}
Description This command is used to create an OSPF virtual interface.
Parameters
<area_id>
−
A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<neighbor_id>
−
The OSPF router ID for the remote area. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area’s Area Border Router. The router
ID of the neighbor router.
hello_interval <sec 1-65535>
−
Allows the specification of the interval
between the transmission of OSPF Hello packets, in seconds.
Between 1 and 65535 seconds can be specified. The Hello Interval,
Dead Interval, Authorization Type, and Authorization Key should be
the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the length
of time between the receipt of Hello packets from a neighbor router
before the selected area declares that router down. An interval
between 1 and 65535 seconds can be specified. The Dead Interval
must be evenly divisible by the Hello Interval.
authentication – Enter the type of authentication preferred. The user
may choose between:
none – Choosing this parameter will require no
authentication.
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive password
of no more than 8 characters.
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
Restrictions Only administrator-level users can issue this command.
Usage Example
To create an OSPF virtual interface: