BENSHAW RSi GM2 Series, Инструкция по эксплуатации

Страница: 195 / 282

RS-485 Communication Features
185
890054-00-00
GM2 Series VFD
Saving Parameters Defined by Communication
If you turn off the inverter after setting the common area parameters or keypad parameters via
communication, the changes are lost and the values revert to the previous setting.
Set address 0h03E0 to 0 and then set it again to 1 via communication saves the existing parameter
settings. However, setting address 0h03E0 to 1 and then setting it to 0 does not carry out the
same function.
Total Memory Map for Communication
Communication Area Memory Map Description
Communication common
compatible area
0h0000 – 0h00FF GM2 compatible area
Parameter registration type area 0h0100 – 0h01FF
Areas registered at CM.31 – 38 and CM.51 –
58
GM2 communication
common area
0h0300 – 0h037F Inverter monitoring area
0h0380 – 0h03DF Inverter control area
0h03E0 – 0h03FF Inverter memory control area
0h0400 – 0h0FFF Reserved
0h1100 dr Group
0h1200 bA Group
0h1300 Ad Group
0h1400 Cn Group
0h1500 In Group
0h1600 OU Group
0h1700 CM Group
0h1800 AP Group
0h1B00 Pr Group
0h1C00 M2 Group
Parameter Group for Data Transmission
By defining a parameter group for data transmission, the communication addresses registered in
the communication function group (CM) can be used in communication. Parameter group for data
transmission may be defined to transmit multiple parameters at once, into the communication
frame.
Group Code Name Setting Setting Range Unit
CM
31 – 38
Output communication
address x
- 0000 – FFFF Hex
51 – 58
Input communication
address x
- 0000 – FFFF Hex
Currently Registered CM Group Parameter
Comm. Address Parameter Assigned Content by Bit
0h0100 – 0h0107
Status Parameter-1 –
Status Parameter-8
Parameter communication code value registered at
CM.31
– 38 (Read-only)
0h0110 – 0h0117
Control Parameter-1 –
Control Parameter-8
Parameter communication code value registered at
CM.51
– 58 (Read/Write access)