202
The process requires that both the device’s original remote and the KP21R remote be available.
Before pressing any buttons on either remote, place them so that the IR transmitter on the remote
from the device to be programmed is facing the
Infrared Lens [triangle 50]
on the KP21R
remote. The two remotes should be no more than an inch apart and there should not be any
direct sunlight or other bright light source near the remotes.
Learn Device
1. Press and hold the
REM MENU Button [triangle 33]
for about three seconds while the
message:
HOLD BUTTON FOR 3 SECONDS
appears in the remote’s LCD
Information
Display [triangle 3]
. Release the button when the red light under the
Set Button [triangle
15]
turns on.
2. The remote’s
MAIN MENU
message will appear in the LCD display and the
Set Button
[triangle 15]
will remain illuminated in red. Press the
▲
Navigation Button [triangle 13]
once so that
LEARN CODE
appears on the bottom line of the LCD screen, as shown in
Figure 135
.
Figure 135
3. Press the
Set Button [triangle 15]
. The message in the LCD display will change to the
LEARN CODE
menu (
Figure 136
). The bottom line will default to the
LEARN DEVICE
option.
Figure 136
Press the
Set Button [triangle 15]
. The message:
PRESS DEVICE TO BE PROGRAMMED
will appear in the LCD display. Press the remote
Input Select Button [triangle 4]
to which
the IR command is to be added. The message:
PRESS BUTTON ON ORIGINAL REMOTE
will appear in the LCD display.
With the two remotes properly positioned, lens to lens, press the button on the original
remote and hold it until:
CODE LEARNED CONTINUE
appears in the LCD display. The
Set
Button [triangle 15]
will illuminate red. Press the
Set Button [triangle 15]
to ‘save’ the
command. The red light will turn off. The message:
PRESS DEVICE TO BE PROGRAMMED
will again appear in the LCD display. Either: press another
Input Select Button [triangle 4]
to teach additional commands to other input select buttons, or press the
REM MENU Button
[triangle 33]
to exit LEARN Menu and return to normal operation.
4. Press the
Input Select Buttons [triangle 4]
just programmed to confirm proper system
performance. If a code wasn’t learned or if the wrong code was inadvertently programmed,
repeat the previous steps to make corrections.
Learn Button:
1. Press and hold the
REM MENU Button [triangle 33]
for about three seconds while the
message HOLD BUTTON FOR 3 SECONDS
appears in the remote’s LCD
Information
Display [triangle 3]
. Release the button when the red light under the
Set Button [triangle
15]
turns on.
Содержание AVR21EN
