Audioaccess AVR21EN, Руководство по установке, Страница: 163 / 222

163
AVH21 CONFIGURATION
Whether using one AVH21 or three, the Hubs need to be configured for ‘Hub Number’ and ‘Zone
Group’ identification. (This is not the same as the Entertainment, Wake-Up and Sleep Groups that
are configured in the
ZONE SETUP Menu.) This allows the system management software to keep
track of which zones are doing what. The Hub Configuration Switch [pentagon 28] on the
AVH21 Top Panel identifies each Hub and its Zone Group.
AVH21 Hub Configuration Switch
The settings of the Hub Configuration Switch [pentagon 28] correspond to the ‘keyed’
openings in the three lexan Status Panel Labels included with each AVH21. When the switches
have been set, match the appropriate label, remove the adhesive backing and carefully place the
label in the recess on the AVH21 Top Panel. The settings for the
Hub Configuration Switch
[pentagon 28] are:
Figure 89 AVH Hub Configuration Switch Settings
HEAD END CONNECTIONS
AVH21 Connections
Power In
1. Using 14-16AWG four-conductor stranded wire, strip approximately ¼” and twist the ends
until there are no loose strands that can cause shorts.
2. Insert the twisted ends into the appro and - slots on the included plug-in connectors
and tighten with a small blade screwdriver. Pull the wire slightly to confirm connection. Check
polarity on both ends.
3. Connect the plug-in connectors to the Power In Terminal [pentagon 9] on the AVH21 and to
the AV/Audio Hub 1/2/3 Terminal [rectangle 5] on the WPS21 to power the AVH21 and
associated KP21 Keypads as shown in Figure 90 .
4. In larger systems using multiple Hubs, repeat steps 1-3 above for each AVH21/WPS21 pair.
Be sure to be consistent in matching the appropriate AVH and WPS pairs and associated
KP21’s. (Figure X). DO NOT connect more than one AVH21 to a single WPS21.