Audioaccess AVR21EN, Руководство по установке

Страница: 16 / 222

16
PRE-WIRE
As part of System Planning, full consideration should be given to the wiring infrastructure that will
be required to utilize the maximum capabilities of the Audioaccess W.H.E.N.
Main Room
This section is an overview of the pre-wiring that that should be done during construction and
prior to installation for the Main Room section of the system.
Speakers (Front, Side, Rear)
Pull quality, 16AWG, 2-conductor stranded speaker wire from each speaker location to the
AVR21EN. Each paired run, (Front right/left; Side right/left; Rear right/left) should be equal
lengths to help assure proper audio reproduction. Example: if the system components are
installed on one side of the room and the Front right speaker requires a 10 foot run but the Front
left speaker requires a 20 foot run, both front speakers should have runs of 20 feet.
Video Monitor (Monitor Out, C-Video, S-Video, Monitor, Y, Pb, Pr)
If the video display is going to be mounted somewhere other than in the same wall unit as the
AVR21EN, pull the recommended video cables and terminate with an appropriate wall plate. The
AVR21EN will up-convert all video sources to Component Video or HDMI so Composite Video
and S-Video cables typically will not be required. Pull 4 RG6 coaxial cables for Component Video
and a spare, as well as an HDMI cable to where the Main Room Video Display will be mounted or
to where a projector will be installed. Terminate with a multi-terminal wall-plate.
Door A/V
Audio –
Pull shielded audio cable from the door monitoring device to the AVR21EN.
Video – Pull RG6 coaxial cable from the door monitoring device to the AVR21EN.
Trigger Out
Pull 24-18AWG two-conductor stranded wire from the AVR21EN to a device such as a screen, lift,
drapes etc., to be triggered with 12V.
Remote (External IR Receiver)
Pull 24-18AWG three-conductor, stranded non-shielded wire from where the IR receiver will be
mounted to the AVR21EN.
Multiroom Link (Multiroom Application With up to Two Remote Audio Only Zones)
Pull one, CAT5e cable from each Multiroom Link terminal on the AVR21EN rear panel to each of
up to two KP21 Keypads to provide control and digital audio signals up to two Remote Rooms. It
is highly recommended that these CAT5e cables be run through the location that would be used
for installing AVH21Hubs, should the system be expanded for additional zones at a later date.
Multiroom Link (AVH21Hub Multiroom Application up to 20 Zones)
Pull one CAT5e cable from the AVR21EN to where the AVH21 A/V Hubs will be installed.
Video Source Out (Multiroom Application Only)
Pull One RG6 coaxial cable for each source to be distributed to Remote Rooms from the
AVR21EN to the AVH21(s) to provide composite video to the Remote Rooms. Pulling coax for all
six common sources is recommended even if there will not initially be six A/V components.
NOTE: All other connections will be done after construction and installation are finished. See
also: AVR21EN Connections for additional information.