Audioaccess AVR21EN, Руководство по установке

Страница: 105 / 222

105
12. When pressing one of the numeric keys in Step 10 or 11 causes the device being
programmed to turn back on, follow the instructions shown in Figure 47 and press the Set
Button [oval 18] within five seconds of the device turning on. After you press the Set button
[oval 18] , the top line of the LCD display will read SAVING… and then the word SAVED will
flash four times in the center of the bottom line.
13. When the codes are saved, the remote will return to normal operation, and whenever you
press the TV or GAME/CAM Button that was just programmed, the codes for the new device
will be used.
Learning Commands
On occasions when the AVR remote does not contain the codes for a particular product’s remote
in its built in library, or when you wish to program a missing or special function into one button of
a device, the AVR remote’s learning capability allows you to do that.
There are two options in LEARN CODE.
Learn Device: This option allows adding a single IR command to the AVR21ENR1 Input Select
Buttons [oval 4] , for functions such as PLAY for a DVD/CD, VR etc. It can also be used to output
any command that may be desirable when selecting a particular source such as issuing a screen
aspect ratio command, or other video display command.
Learn Button: This option allows adding a single IR command to any button on the AVR21ENR1.
This is useful when a particular code is not included in the on-board IR code library or for adding
a special function for another device when a particular source has been selected. NOTE: Learn
Button can only be used for learning IR commands for TV and Game/CAM. TV and Game/CAM
are the only two settings that output a devices original IR codes directly. For all other devices,
(common sources) the AVR21ENR1 outputs proprietary commands that are interpreted by the
AVR and converted to the original codes. To add IR commands to buttons for these other devices,
use the OSD Menu Learning as described in
REMOTE CONTROL SETUP/LEARN CODES
section.
To teach commands from one product’s remote into the AVR remote, follow the steps below:
The process requires that both the device’s original remote and the AVR remote be available.
Before pressing any buttons on either remote, place them so that the IR transmitter on the remote
from the device to be programmed is facing the
Infrared Lens [oval 53] on the AVR remote. The
two remotes should be no more than an inch apart and there should not be any direct sunlight or
other bright light source near the remotes.
Learn Device
1. Press and hold the REM MENU Button [oval 36] for about three seconds while the message
HOLD BUTTON FOR S SECONDS appears in the remote’s LCD Information Display [oval
3] . Release the button when the red light under the Set Button [oval 18] appears.
2. The
remote’s MAIN MENU message will appear in the LCD display and the Set Button [oval
18] will remain illuminated in red. Press the ▲ Navigation Button [oval 16] once so that
LEARN CODE appears on the bottom line of the LCD screen, as shown in Figure 48.
Figure 48