114
• When any button is held for more than thirty seconds, the LCD will turn off and the remote will
stop transmitting the codes to conserve battery life.
MAIN ROOM OPERATION
Basic Operation
Once you have completed the initial setup and configuration of the AVR21EN, it is simple to
operate and enjoy. The following instructions will help you maximize the enjoyment of your new
receiver:
Turning the AVR21EN On or Off
• When using the AVR21EN for the first time, you must press the
Main Power Button [square
1]
to turn the unit on. This places the unit in a Standby mode, as indicated by the LED in the
Standby/On Button [square 2]
turning red. Once the unit is in Standby, you may begin a
listening session by pressing the
Standby/On Button [square 2]
on the front panel, or the
remote
Power On Button [oval 2]
. This will turn the unit on and return the AVR to the input
that was last used. The unit may also be turned on from Standby by pressing any of the
Input
Selector Buttons [oval 4]
on the remote or the
Input Source Selector Button [square 15]
on
the front panel.
Whenever the AVR is turned on, you will see all of the front-panel indicators light up for a few
seconds. This is normal, and it is part of the unit’s power-on self test. The LED in
Standby/On
Button [square 2]
will turn green.
NOTE: After pressing one of the
Input Selector Buttons [oval 4, square 15]
to turn the unit on,
press the
AVR Selector [oval 5]
to set the remote control to the AVR21EN functions.
To turn the unit off, simply press the
Standby/On Button [square 2]
on the front panel or the
Power Off Button [oval 1]
on the remote. Power will be shut off to any equipment plugged into
the rear-panel
Switched AC Accessory Outlet [circle 31]
, equipment managed with the SPF
Source Power Flags or that have separate ON/OFF IR power commands. The LED in
Standby/On Button [square 2]
will turn red. NOTE: If any of the multiroom zones are active, the
Main Room activities will shut down, but the AVR will remain active with the massage:
MULTI-
ROOM ON
in the AVR
Lower Display Line [square 34
to indicate system activity.
When the remote is used to turn the unit “off,” it is actually placing the system in a Standby mode,
as indicated by the red LED in the
Standby/On Button [square 2].
Main Room Sleep Mode
To program the AVR21EN for automatic turn-off, first press the
AVR Button [oval 5]
on the
remote, then press the
Sleep Button [oval 33].
Each press of the button will decrease the time
before shut-down in the following sequence:
Figure 72 Main Room Sleep Mode Times
Содержание AVR21EN
