Arctic Cat 2014 400, Руководство по обслуживанию

Страница: 32 / 124

29
KC283
8. Pump the hand brake lever; then engage the brake
lever lock.
9. Secure the hub nut (from step 6) to the shaft. Tighten
to 200 ft-lb.
10. Install a new cotter pin and spread the pin to secure
the nut.
11. Install the wheel; then using a crisscross pattern,
tighten to 40 ft-lb (steel) or 80 ft-lb (aluminum).
12. Remove the ATV from the support stand.
Measuring/Adjusting
Toe-Out
1. Thoroughly wash the ATV to remove excess weight
(mud, etc.).
2. Refer to the specifications and ensure the tires are
properly inflated to the recommended pressure.

NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not to
push down or lift up on the front end; then turn the
handlebar to the straight ahead position.

NOTE: When measuring and adjusting, there
should be a normal operating load on the ATV (with-
out an operator but with Arctic Cat approved acces-
sories).
4. Measure the distance from the outside edge of each
handlebar grip to equal reference points on each side.
5. Adjust the handlebar direction until the two measure-
ments are equal; then secure the handlebar.

NOTE: Care must be taken not to allow the handle-
bar to turn while securing it.

NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
6. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
AF789D
7. Measure the distance between the marks (at a height
parallel to the belly panel) at the front side; then
record the measurement.
8. Push the ATV forward until the marks are parallel to
the belly panel on the back side; then measure the
distance between the marks.
9. The difference in the measurements must show
1/8-1/4 in. toe-out (the front measurement 1/8-1/4 in.
more than the rear measurement).
10. If the difference in the measurements is not within
specifications, adjust both tie rods equally until
within specifications.

NOTE: Prior to locking the jam nuts, make sure the
ball joints are at the center of their normal range of
motion and at the correct angle.
733-559A
Front Rack
REMOVING
1. Remove the cap screws and lock nuts securing the
rack to the frame and front fender panel.
2. Remove the front rack from the ATV.
CLEANING AND INSPECTING
1. Clean all rack components using a pressure washer.
2. Inspect all welds for cracking or bending.
3. Inspect threaded areas of all mounting bosses for
stripping.