AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 85 / 108

Advanced Administration
71 UDM-0102 and UDM-RX02 Operation/Reference Guide
Backend Commands
In case of human error the Command Line can be used to perform several Administrative tasks on the
UDM-0102.
Changing the Login Password
1.
Create a hyperterminal session with the UDM Hub using default serial connections.
2.
To change the password enter the original password and new password separated by a full colon at the
login prompt.
For example type in admin:password at the login prompt, to change the password from "admin" to
"password".
3.
Reset the Hub. A power off then on is now required.
Obtaining the Hub’s IP Address Via the Command Line
1.
Type i at the command prompt (FIG. 85).
2.
Push Enter .
Setting the Hub’s IP Address Via the Command Line
1.
Type i <ip address> at the command prompt.
2.
Push Enter .
Multi Format Inputs
The multi format inputs located at the rear of the Hub are numbered 129 & 132 for administrative purposes.
1.
To check the input port configuration, type in the following – a question mark followed by the Input
Number (129, 130, 131 or 132). For example:
? 129
2.
Push Enter .
3.
The following information will be displayed (FIG. 86);
FIG. 85 Issuing the i command
Multi format inputs
Input Input Number
A 129
B 130
FIG. 86 Querying a multi format input port