AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 106 / 108

UDM-0102 Control Protocol
92 UDM-0102 and UDM-RX02 Operation/Reference Guide
Get Hub or Port Identification and System Information
Retrieves a string identifier from the Hub, together with some predefined information. The string identifier is
the same as that set in the command above, the first 128 bytes are used for predefined system information
(defined below). Length is the length of the ID string if present.If port is specified (non zero), then only port
information is returned (no ID string).
Return status:
Predefined system information values:
Reset Controller
Resets the controller - reboots as though powered on - the second 156 (inverted 99) in packet is to guard
against accidental resets.
Return status:
Status Values
Status replies can be either general or specific to certain commands. Status values are always returned in the
byte after the returned command in the returned status packet. In general, success is indicated by a single
value, failure is indicated by as specific a return value as possible:
Byte # 0 1 2 3 4 5
Byte value 78 User defined Port User defined User defined User defined
Byte # 0 1 2 3 4...127 128...128
Byte value 78 Status Port Length Predefined values Identification string
Byte offset (from 4) Hub information Port information
0 Chassis type Port version number - major
1 Number of ports Port version number - minor
2 Controller version number - major Port version - revision
3 Controller version number - minor
4 Controller version number - revision
Byte # 0 1 2 3 4 5
Byte value 99 User defined 156 User defined User defined User defined
Byte # 0 1 2 3 4 5
Byte value 99 Status 156 User defined User defined User defined
Status value Description
1 Command completed successfully
64 Command fail
65 Incorrect parameters
66 Incorrect port parameter
67 Incorrect input parameter
70 Session not authenticated
80 Input is disabled
81 Port is locked
82 Port is disconnected
90 Command has timed out (no response from port)