AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 38 / 108

UDM-0102 Configuration - Status Page
24 UDM-0102 and UDM-RX02 Operation/Reference Guide
Video compensation settings can also be configured at the UDM-RX02 Receivers via two methods;

Via the UDM-RC10 Remote Control (see the Compensating Video Via the UDM-RC10
Remote section on page 75).

Via hyper terminal session via the serial connector on the UDM-RX02 (especially effective when
using long runs). See the
Advanced Administration section on page 67for details.
Selecting a Control Protocol for the Output Port
Protocols for Serial and IR devices used in the system can be created via options in the Protocols page (see the
Configuration - Protocols Page section on page 51). These protocols allow the UDM-0102 to control
connected serial and IR devices.
Once one or more protocols have been defined in the Protocols page, these protocols are available for selection
in the
Protocol drop-down menu in the Port Configuration page (FIG. 20):
Dual Output Mode
Dual Output mode permits a single output to be viewed as two separate output types. For example a port could
be configured for the dual output of VGA and Component video. This means at the UDM-RX02 end the video
could be delivered to two separate display devices over the relevant connections at the UDM-RX02.
However, the output via the component connectors can only be RGBs; separate syncs are not available on this
connection.
To place a port into Dual Output mode:
1.
Click on the Port hyperlink on the Status page to invoke the Port Configuration page
2.
Click on the Dual Output checkbox to permit the port to display the single input as 2 separate types at
the UDM-RX02 (FIG. 21).
FIG. 19 Skew controls
1
2
3
Each radio button represents a 2ns delay.
FIG. 20 Protocol drop-down menu
FIG. 21 Port Configuration Options page - Dual Output enabled for a selected port
Dual Output enabled for this Port