AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 31 / 108

UDM-RX02 Wiring and Connections
17 UDM-0102 and UDM-RX02 Operation/Reference Guide
Connecting an IR03 External IR Receiver Module to the IR Rx Port
If pass-through mode (where a device such as a DVD or VCR can be controlled via an RC-02 remote control)
is required then an IR03 External IR Receiver Module will be needed to receive IR commands from the remote
control.
An IR03 External IR Receiver Module is also needed if the UDM-RX02’s video compensation is to be done
via a remote control (see the
Compensating Video Via the UDM-RC10 Remote Controller section on page 79
for details).
IR Tx (IR Transmit) Port
The IR Tx port issues IR commands from the UDM-RX02 to a controlled device. One IR device (such as DVD
player or VCR) can be connected to the UDM-RX02 via the IR Tx port, and controlled via the UDM-0102’s
WebConsole or via remote control.
Connecting an IR01 External IR Emitter Module to the IR Tx Port
To issue IR commands to the display device such as power on or power off, an IR01 IR Emitter Module (FG-
IR01) is needed.
1.
Connect the IR Emitter Module cable to the IR Tx connector on the UDM-RX02.
2.
Run the other end of the cable to the display device, and attach the IR Emitter over the device’s IR sensor
by removing the cover on the reverse side of the IR Emitter.
3.
The UDM-RX02 is now capable of issuing IR commands to the display device.
IR commands for each device on the system have to be learned by the UDM-0102 in order to function
properly. Refer to the
Creating and Learning an IR Protocol section on page 59 for instructions on learning a
device’s IR commands.
AUDIO Outputs
The UDM-RX02 provides standard RCA (L/R) output connectors for analog audio output and S/PDIF for
digital audio output. Use the audio output appropriate for the display device to be used with each UDM-RX02.
VIDEO Outputs
The UDM-RX02 provides several video output connectors to accommodate various connection types on
display devices. The UDM-RX02 can output CVBS (Composite), VGA, S-Video or Component video. Use
the video output appropriate for the display device to be used with each UDM-RX02:
1.
Attach an appropriate video cable to the respective video output connector (either CVBS (Composite),
VGA, S-Video or Component) on the UDM-RX02.
2.
Run the other end of the cable to a video input connector on the display device; connect firmly.
3.
Connect any audio to the appropriate analog (RCA) audio connectors or digital (SPDIF) connector.
IR devices controlled via the IRTX ports are typically installed within the same
equipment rack as the UDM-RX02.
Ensure the position of the device corresponds to the position assigned in the Devices
option of the UDM-0102’s WebConsole.