AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 30 / 108

UDM-RX02 Wiring and Connections
16 UDM-0102 and UDM-RX02 Operation/Reference Guide
UDM Hub Port (RJ45)
The UDM-RX02 connects to the UDM-0102 Hub via the UDM HUB connector. This is a standard RJ45
connector, and the UDM-RX02 can be connected via standard Cat5/5e/6 cabling.

Refer to the UDM Port (RJ45) section on page 6 for pinout details.

Refer to the UDM-0102 Wiring and Connections section on page 3 for information on connecting
the UDM-0102 to the network.
Serial (RJ12) Port
The SERIAL (RJ12) port allows administrators to control the various functions to the UDM-RX02 from a
command line prompt and terminal connection.

Requires a DB9-to-RJ12 adapter cable (FG-RS01) to connect to a PC.

Default settings = 9600, 8 bit, No Parity, 1 Stop Bit.
The Serial port can also be used as a control port for sending serial data to a connected device. In this mode the
UDM-RX02N supports baud rates from 1200 - 115200. If a display device is controlled using a serial
connection instead of IR, then a serial cable is connected from the UDM-RX02N to the serial port on the
display device.
Depending on the screen manufacturer, it may be necessary to introduce a cross into this connection by instead
using the FG-RS02 cable, or a null modem DB9-DB9 adaptor with the FG-RS01. In some cases the null
modem adaptor may need a link between RTS/CTS at the DB9 end.
For example, NEC LCD panels act as DTE equipment and work with standard serial cable, while Fujitsu and
Panasonic Plasma screens act as DCE equipment and therefore require cross connections.
To connect to a display device using a serial cable:
1.
Connect a serial cable to the UDM-RX02N’s SERIAL port.
2.
Run the serial cable (observing distance limitations) to the display device’s serial port and connect.
Refer to the Serial (RJ12) Port section on page 4 for default communication settings and RS01 (DB9-to-RJ12
Adapter) Cable Pinouts.
IR Rx (IR Receiver) Port
The IR Rx port is a 3.5mm stereo input port, which allows you to connect an (optional) IR03 External IR
Receiver Module (FG-IR03).
The IR Rx port has two purposes:

To learn and create new IR protocols. Refer to the Creating and Learning an IR Protocol section on
page 59 for details.

To control an IR-controlled device via Passthrough mode. Refer to the Passthrough Mode section
on page 29 for information.
The baud rate on the UDM-RX02N must match the baud rate as the receiver is set up
for. For example, if the baud rate has been changed to 115200 for a certain display,
then you’ll need to change your terminal to the same 115200 baud rate.
Refer to the UDM-0808-SIG / UDM-RX02N Operation/Reference Guide for pinout
details on the SERIAL (RJ12) connector.
The serial cable must be pinned out according to the Manufacturer’s instructions.
Failure to do so will result in serial commands failing.