AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 72 / 108

Configuration - Protocols Page
58 UDM-0102 and UDM-RX02 Operation/Reference Guide
Updating the UDM-RX02 Receiver With the Serial Protocol
The UDM-RX02 Receiver which will issue serial commands to a controlled device must be connected to the
UDM port on the UDM-0102 (rear panel). See the
UDM Port (RJ45) section on page 6 for details.
Once the Serial commands have been defined, follow these steps to update the UDM-RX02 Receiver with the
new protocol:
1.
On the Status page (see FIG. 19 on page 27), click on the port number to which the serial device is
attached. This invokes the Port Configuration options for the selected Port.
2.
Click on the Protocol drop-down menu (FIG. 72).
3.
Select the Serial protocol which this UDM Receiver will download.
4.
Click Send Settings to RX to send the Serial protocol to the RX02 connected to this port. This may take
a few minutes depending on how many commands are contained in the protocol.
5.
A message will appear saying “Loading Protocol – Please wait”. Once this has disappeared the Serial
protocol has been downloaded to the UDM Receiver. Commands can now be sent from the Hub
WebConsole to the serial device.
A new table for this device’s Serial control is what is actually being created. When the administrator decides to
create further commands particular to this serial device they will be stored within this table.

If new commands are to be created in the future, ensure the correct Serial protocol has been selected
before defining new commands to ensure commands are stored in the correct table.

There is one protocol/table per UDM-RX02.
FIG. 72 Port Configuration options - Protocol drop-down menu
Select the Serial protocol to
download to the UDM Receiver
connected to this Port
Serial commands are stored in the UDM-RX02 - be sure to keep any serially
programmed UDM-RX02 units associated with the correct display device type.