AMX Endeleo Multi-Format Receiver UDM-RX02, Руководство по эксплуатации/справочник

Страница: 68 / 108

Configuration - Protocols Page
54 UDM-0102 and UDM-RX02 Operation/Reference Guide
3.
Select the appropriate Baud Rate and Parity settings from the drop-down menus.
4.
Click on Initialize to initialize the UDM-RX02.
5.
Enter the serial string equivalent to perform the desired control function in the Serial Command text field
(see FIG. 70).
The UDM-0102 supports a predetermined set of actions (commands), against which you can associate
serial strings. For a listing of supported commands, check the
Control drop-down menu.

Either enter ASCII text directly into the serial command box or where a HEX code is required.

Precede the double-digit HEX code with a “ % ” symbol.
The example below (FIG. 71) is from a Panasonic screen where the actual command string requires a
“
Start of Text ” header ( stx ), the character command POF (Power Off) and a “ End of Text ” header ( etx ).
Both the headers have therefore been added in HEX and the character string uses ASCII.
6.
Once you have finished entering the string, click the Test hyperlink to send the string to the device
connected.
Repeat the process as many times as required to test a complete set of controls before saving them to the
protocol library.
Examples of Serial Controls
The video mode select commands ( VGA select etc.) are extremely useful commands and enable a serial string
to be associated with a change of input type, allowing a display automatically switched to the appropriate input
port on a change of the video type from the UDM-0102.
See the Appendix A: Ascii / Hex Conversion section on page 85 for details.
FIG. 70 Serial configuration options
Select Baud Rate
Click to initialize the UDM-RX02
Enter Serial command string
Test the entered command
Select Parity
Any serial protocols that have been created previously are also available via this
drop-down menu. Refer to the Creating and Learning an IR Protocol
section on
page 59 for details.
FIG. 71 Panasonic screen - command screen
Screen Type Command Ascii code Hex code
NEC 30/40” LCD Power Off 00!%0D %00%00%21%0D
Power On 00”%0D %00%00%22%0D
CVBS Input Select 00_v1%0D %00%00%5f%76%31%0D
DSR Data Set Ready
Panasonic Power Off %02POF%03 %02%50%4F%46%03