Chapter 7 Broadband
Nebula Mobile Router User’s Guide
115
7.5 Cellular APN
Click
Network Setting
>
Broadband
>
Cellular APN
to display the following screen. Use this screen to
manage the APNs that Zyxel Device is connected to.
Network
Monitoring
Use this field to allow Zyxel Device to try reconnecting to the base station if the cellular
connection is lost. After the third try, the Zyxel Device will reboot to try to reconnect with the base
station. The LED will blink red to indicate that it is rebooting.
Note: This feature only works if there is a previous cellular connection between the
Zyxel Device and the base station.
Proxy ARP Feature
Proxy ARP
Enable this to set your Zyxel Device as a server to handle ARP queries from different subnets. The
Zyxel Device will offer Zyxel Device’s own MAC address as an reply.
FQ_Codel Setting
FQ_Codel
Select this field to enable
FQ_Codel
on the Zyxel Device. Clear this field if your network does not
have much real-time traffic.
Use Fair Queuing with Controlled Delay (FQ_Codel) to reduce delays in traffic that could affect
real-time communications, such as video conferencing, live streaming, and voice over Internet
phone calls
FQ_Codel limits traffic throughput, by dropping traffic so as to reduce buffer queuing that causes
delays. It does not prioritize traffic by type.
APN Manual
Mode
Disable this to have the Zyxel Device configure the APN (Access Point Name) of a cellular
network automatically. Otherwise, Click this to enable (
) and enter the APN manually in the
field below.
APN
This field allows you to display the Access Point Name (APN) in the profile.
Enter the Access Point Name (APN) provided by your service provider. Connections with different
APNs may provide different services (such as Internet access or MMS (Multi-Media Messaging
Service)) and charging method.
You can enter up to 64 printable ASCII characters. Spaces are allowed.
Username
Enter the user name. You can enter up to 64 printable ASCII characters. Spaces are allowed.
Password
Enter the password associated with the user name above. You can enter up to 64 printable ASCII
characters. Spaces are allowed.
Authentication
Type
Select the type of authentication method peers use to connect to the Zyxel Device in cellular
connections.
In Password Authentication Protocol (
PAP
) peers identify themselves with a user name and
password. In Challenge Handshake Authentication Protocol (
CHAP
) additionally to user name
and password the Zyxel Device sends regular challenges to make sure an intruder has not
replaced a peer. Otherwise select
PAP/CHAP
or
None
.
PDP Type
Select
IPv4
if you want the Zyxel Device to run IPv4 (Internet Protocol version 4 addressing system)
only.
Select
IPv4/IPv6
if you want the Zyxel Device to run both IPv4 and IPv6 (Internet Protocol version 4
and 6 addressing system) at the same time.
Apply
Click this to save your changes.
Cancel
Click this to exit this screen without saving.
Table 29 Network Setting > Broadband > Cellular WAN (continued)
LABEL
DESCRIPTION
Summary of Contents for LTE3301-PLUS
