ZyXEL Communications LTE3301-PLUS, User Manual

Page: 113 / 361

Chapter 7 Broadband
Nebula Mobile Router User’s Guide
113
7.3 Ethernet WAN
Use this screen to have a LAN port act as an Ethernet WAN port. When the switch goes to the right, the
LAN port acts as an Ethernet WAN port. Otherwise, the LAN port remains as a LAN port. Click
Apply to
save your changes back to the Zyxel Device. See Section 1.1.1 on page 17 to see if your Zyxel Device
supports Ethernet WAN.
Note: The Ethernet WAN has priority over the cellular WAN. When both WAN interfaces are
available, the Zyxel Device uses the Ethernet WAN connection. If the Ethernet WAN
interface is down, the Zyxel Device will automatically switch to use the cellular WAN.
Click Network Setting > Broadband > Ethernet WAN to display the following screen.
Figure 63 Network Setting > Broadband > Ethernet WAN
464XLAT Enable this to have the Zyxel Device translate outgoing IPv4 packets to IPv6 packets.
Use this function if you want to use IPv4 devices and services when your ISP provides an IPv6-only
mobile network.
See Section 7.1.2 on page 107 for more information about 464XLAT.
Auto Prefix64 Enable this to have the Zyxel Device automatically add the IPv6 prefix assigned by your ISP to
the outgoing IPv4 packets.
Disable this and configure the Static IPv6 Prefix field if you want to manually assign an IPv6 prefix.
Static IPv6 Prefix Enter an IPv6 prefix that the Zyxel Device adds to the outgoing IPv4 packets.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
Table 28 Network Setting > Broadband > Add or Edit New WAN Interface (continued)
LABEL DESCRIPTION