Chapter 7 Broadband
Nebula Mobile Router User’s Guide
111
IPv4/IPv6 Mode
This shows
IPv4 IPv6 DualStack
.
IPv4 IPv6 DualStack allows the Zyxel Device to run IPv4 and IPv6 at the same time.
VLAN
Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the
right
, the function is enabled. Otherwise, it is not.
802.1p
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The
greater the number, the higher the priority level.
802.1q
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
MTU
MTU
Enter the MTU (Maximum Transfer Unit) size for this traffic.
IP Address
Obtain an IP
Address
Automatically
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP
assigns you a different one each time you connect to the Internet. Select this if you have a
dynamic IP address.
Static IP Address Select this option If the ISP assigned a fixed IP address.
IP Address
Enter the static IP address provided by your ISP.
Subnet Mask Enter the subnet mask provided by your ISP.
Gateway IP
Address
Enter the gateway IP address provided by your ISP.
DNS Server
Select
Obtain DNS Info Automatically
if you want the Zyxel Device to use the DNS server
addresses assigned by your ISP.
Select
Use Following Static DNS Address
if you want the Zyxel Device to use the DNS server
addresses you configure manually.
Primary DNS
Server
Enter the first DNS server address assigned by the ISP.
Secondary DNS
Server
Enter the second DNS server address assigned by the ISP.
Routing Feature
NAT
Click this switch to activate or deactivate NAT on this connection. When the switch goes to the
right
, the function is enabled.
IGMP Proxy
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish
membership in a Multicast group – it is not used to carry user data.
Click this switch to have the Zyxel Device act as an IGMP proxy on this connection. When the
switch goes to the right
, the function is enabled.
This allows the Zyxel Device to get subscribing information and maintain a joined member list for
each multicast group. It can reduce multicast traffic significantly.
Apply as Default
Gateway
Click this switch to have the Zyxel Device use the WAN interface of this connection as the system
default gateway. When the switch goes to the right
, the function is enabled.
Fullcone NAT
Click this switch to enable or disable fullcone NAT on this connection. When the switch goes to
the right
, the function is enabled.
This field is available only when you activate
NAT
.
In fullcone NAT, the Zyxel Device maps all outgoing packets from an internal IP address and port
to a single IP address and port on the external network. The Zyxel Device also maps packets
coming to that external IP address and port to the internal IP address and port.
Table 28 Network Setting > Broadband > Add or Edit New WAN Interface (continued)
LABEL
DESCRIPTION
Summary of Contents for LTE3301-PLUS
