ZyXEL Communications LTE3301-PLUS, User Manual

Page: 186 / 361

Chapter 10 Routing
Nebula Mobile Router User’s Guide
186
Figure 117 Network Setting > Routing > Static Route > Add New Static Route
The following table describes the labels in this screen.
10.2.1.1 An Example of Adding a Static Route
In order to extend your Intranet and control traffic flowing directions, you may connect a router to the
Zyxel Device’s LAN. The router may be used to separate two department networks. This tutorial shows
how to configure a static routing rule for two network routings.
In the following figure, router R is connected to the Zyxel Device’s LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1 network) to
computer B (in N2 network), the traffic is sent to the Zyxel Device’s WAN default gateway by default. In
this case, B will never receive the traffic.
Table 64 Network Setting > Routing > Static Route > Add New Static Route
LABEL DESCRIPTION
Active Click to enable ( ) and to activate static route. Otherwise, click to disable.
Route Name Assign a name for your static route (up to 15 characters). Special characters are allowed
except the following: double quote (") back quote (`) apostrophe or single quote (') less than
(<) greater than (>) caret or circumflex accent (^) dollar sign ($) vertical bar (|) ampersand (&)
semicolon (;)
IP Type Select between IPv4 or IPv6 . Compared to IPv4 , IPv6 (Internet Protocol version 6), is designed to
enhance IP address size and features. The increase in IPv6 address size to 128 bits (from the 32-
bit IPv4 address) allows up to 3.4 x 1038 IP addresses. The Zyxel Device can use IPv4 / IPv6 dual
stack to connect to IPv4 and IPv6 networks, and supports IPv6 rapid deployment (6RD).
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing is always based
on network number. If you need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the host
ID.
Subnet Mask If you are using IPv4 and need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the host
ID. Enter the IP subnet mask here.
Use Gateway IP
Address The gateway is a router or switch on the same network segment as the device's LAN or WAN
port. The gateway helps forward packets to their destinations.
Click this switch to enable or disable the gateway IP address. When the switch goes to the right,
the function is enabled. Otherwise, it is not.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving.