Yealink VC110, Administrator'S Manual

Page: 60 / 268

Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
48
Once you have power on the endpoint, it will begin its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file sits in the flash memory of the endpoint. Endpoints come from the factory
with a ROM file preloaded. During initialization, endpoints run a bootstrap loader that
loads and executes the ROM file.
Configuring the VLAN
If the endpoint is connected to a switch, the switch will notify the endpoint about the
VLAN information defined on the switch.
Querying the DHCP (Dynamic Host Configuration Protocol) Server
The endpoint is capable of querying a DHCP server. DHCP is enabled on the endpoint
by default. The following network settings can be obtained from the DHCP server during
initialization:

IP Address

Subnet Mask

Gateway

Primary DNS (Domain Name Server)

Secondary DNS
You need to configure the network settings of the endpoint manually if any of them are
not provided by the DHCP server. For more information on configuring network settings
manually, refer to
Configuring Network Settings Manually on page 61 .
After the initializing process, the endpoint will complete startup by cycling the following
steps:
1. The LED indicator on the VC110 all-in-one unit illuminates solid green.
2. The display device displays the boot up screen.
3. The camera pans to the middle position automatically.
4. The display device displays the setup wizard (when you first start up, or reset the
endpoint, the display device will display the setup wizard)
For more information on how to complete the setup wizard, refer to Setup Wizard
on page 49 .
5. After completing the setup wizard, the display device displays the main screen.