7-1
Chapter 7.
PARAMETER SETUP
7 - 1
Parameter Setup
If you press the
ENT
key when the setting group to be selected is displayed, the
display moves to the individual (minor) item level.
The following table shows the setting groups.
Basic Display State
FUNC key + PARA key
DISP key
Setting group 1 (major items) selection
PARA key
↑
key
↓
key
ENT key
PARA key
Individual items
↑
key,
↓
key,
→
key,
←
key
Setting group 2 (major items) selection
PARA key
↑
key
↓
key
ENT key
PARA key
Individual items
↑
key,
↓
key,
→
key,
←
key
Setting group n (major items) selection
PARA key
↑
key
↓
key
ENT key
PARA key
Individual items
↑
key,
↓
key,
→
key,
←
key
Remarks
This parameter is not displayed when variable parameter
LoC is 2 or 4.
This parameter is not displayed when variable parameter
LoC is 2 or 4.
This parameter is not displayed when variable parameter
LoC is 2 or 4.
This parameter is not displayed when constant-value operation data
modE is 1.
This parameter is not displayed when the output type on CH1 is current
output and setup data C18 is 1.
This parameter is not displayed when the output type on CH1 is heat/cool3D
output and setup data C45 is 1.
This parameter is not displayed when variable parameter
LoC is 2 or 4.
This parameter is not displayed when constant-value operation data
modE is 1.
This parameter is not displayed when the output type on CH2 is current
output and setup data C41 is 1.
This parameter is not displayed when the output type on CH1 is heat/cool3D
output and setup data C45 is 1.
This parameter is not displayed when variable parameter
LoC is 1, 2 or 4.
This parameter is not displayed when variable parameter
LoC is 2 or 4.
This parameter is not displayed when variable parameter
LoC is 2 or 4.
Name
Variable parameters
Variable parameters 2
Event configuration
data
PID parameters 1
PID parameters 2
Setup data
Table data
Constant-value
operation data
Upper
Display
PArA
PAr2
Eu
PId
PId2
SEt
tbL
CnSt
You can enter the parameter setup state when the DCP32 is in the basic display state.
If the DCP32 is not in the basic display state, press the
DISP
key to set the DCP32 to the basic display state.
■
Selecting the setting group in the parameter setup
Parameter setup is divided into two stages: setting group (major item) and
individual item (minor item).
If you press the
FUNC
key + the
PARA
key in the basic display state, the display
changes to selection of setting group (major item), the setting group is displayed
on the upper display, and the lower display goes out.
If you press the
PARA
key,
↑
or
↓
, the setting group display changes in order.
