Yamaha XT1200Z(Z) 2010, Service Manual

Page: 165 / 616

PERIODIC MAINTENANCE
3-28
3. Install:
• Throttle bodies
Refer to “THROTTLE BODIES” on page 7-5.
EAS21131
CHANGING THE COOLANT
1. Remove:
• Left side cowling
Refer to “GENERAL CHASSIS” on page 4-1.
2. Remove:
• Radiator cap “1”
WARNING
EWA13030
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the en-
gine is hot. Scalding hot fluid and steam may
be blown out, which could cause serious in-
jury. When the engine has cooled, open the
radiator cap as follows:
Place a thick rag or a towel over the radiator
cap and slowly turn the radiator cap counter-
clockwise toward the detent to allow any re-
sidual pressure to escape. When the hissing
sound has stopped, press down on the radi-
ator cap and turn it counterclockwise to re-
move.
3. Remove:
• Coolant drain bolt (water pump) “1”
(along with the copper washer “2”)
4. Drain:
• Coolant
(from the engine and radiator)
5. Remove:
• Coolant reservoir “1”
• Coolant reservoir cap “2”
6. Drain:
• Coolant
(from the coolant reservoir)
7. Install:
• Coolant reservoir
8. Install:
• Coolant drain bolt (water pump)
(along with the copper washer )
9. Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
5
4
3
2
1
1
T
R
.
.
Coolant reservoir bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
T
R
.
.
Coolant drain bolt (water pump)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
1
2
1 2
New