FUEL INJECTION SYSTEM
8-73
EAS30670
DIAGNOSTIC CODE TABLE
TIP
The following tables contain information about diagnostic code numbers that do not have a correspond-
ing fault code number. (These items are not listed in “TROUBLESHOOTING DETAILS”.)
1
Connection of multi-function
meter coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected
→
Connect the coupler secure-
ly or repair/replace the wire
harness.
Set the main switch to “ON”.
Fault code number is not dis-
played
→
Service is finished.
Fault code number is dis-
played
→
Go to item 2.
2
Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected
→
Connect the coupler secure-
ly or repair/replace the wire
harness.
Set the main switch to “ON”.
Fault code number is not dis-
played
→
Service is finished.
Fault code number is dis-
played
→
Go to item 3.
3
Wire harness continuity.
Open or short circuit
→
Re-
place the wire harness.
yellow/blue–yellow/blue
Set the main switch to “ON”.
Fault code number is not dis-
played
→
Service is finished.
Fault code number is dis-
played
→
Go to item 4.
4
Abnormal meter unit opera-
tion
Replace the meter assembly. Set the main switch to “ON”.
Fault code number is not dis-
played
→
Service is finished.
Fault code number is dis-
played
→
Go to item 5.
5
Malfunction in ECU.
Replace the ECU.
Diag-
nostic
code
No.
Item
Meter display/Actuation
Procedure
d:51
Radiator fan motor relay
Actuates the radiator fan mo-
tor relay five times at five-
second intervals. (2 seconds
on, 3 seconds off)
Illuminates the engine trou-
ble warning light.
Check that the radiator fan
motor relay is actuated five
times by listening for the
operating sound.
d:52
Headlight relay
Actuates the headlight relay
five times at five-second in-
tervals. (2 seconds on, 3 sec-
onds off)
Illuminates the engine trou-
ble warning light.
Check that the headlight re-
lay is actuated five times by
listening for the operating
sound.
Fault code No.
Er-4
Item
ECU internal malfunction (input signal error): non-registered
data has been received from the meter.
Summary of Contents for XT1200Z(Z) 2010
