ENGINE SPECIFICATIONS
2-3
Oil-pump-housing-to-inner-and-outer-rotor
clearance (scavenging pump)
0.06–0.13 mm (0.0024–0.0051 in)
Limit
0.20 mm (0.0079 in)
Relief valve operating pressure
540.0–660.0 kPa (5.40–6.60 kgf/cm², 78.3–95.7
psi)
Cooling system
Radiator capacity (including all routes)
1.83 L (1.93 US qt, 1.61 Imp.qt)
Coolant reservoir capacity (up to the maximum level
mark)
0.26 L (0.27 US qt, 0.23 Imp.qt)
Radiator cap opening pressure
93.3–122.7 kPa (0.93–1.23 kgf/cm², 13.5–17.8
psi)
Thermostat
Valve opening temperature
69.0–73.0 °C (156.2–163.4 °F)
Valve full open temperature
84.0 °C (183.20 °F)
Valve lift (full open)
8.0 mm (0.31 in)
Radiator core
Width
171.4 mm (6.75 in)
Height
320.0 mm (12.60 in)
Depth
22.0 mm (0.87 in)
Water pump
Water pump type
Single suction centrifugal pump
Reduction ratio
48/48 (1.000)
Impeller shaft tilt limit
0.15 mm (0.0059 in)
Spark plug(s)
Manufacturer/model
NGK/CPR8EB9
Spark plug gap
0.8–0.9 mm (0.031–0.035 in)
Cylinder head
Volume
50.17–51.57 cm³ (3.06–3.15 cu.in)
Warpage limit
0.03 mm (0.0012 in)
Camshaft
Drive system
Chain drive (right)
Camshaft cap inside diameter
24.500–24.521 mm (0.9646–0.9654 in)
Camshaft journal diameter
24.459–24.472 mm (0.9630–0.9635 in)
Camshaft-journal-to-camshaft-cap clearance
0.028–0.062 mm (0.0011–0.0024 in)
Camshaft lobe dimensions
Intake A
40.250–40.350 mm (1.5846–1.5886 in)
Limit
40.150 mm (1.5807 in)
Intake B
29.976–30.076 mm (1.1802–1.1841 in)
Limit
29.876 mm (1.1762 in)
Exhaust A
39.250–39.350 mm (1.5453–1.5492 in)
Limit
39.150 mm (1.5413 in)
Exhaust B
29.950–30.050 mm (1.1791–1.1831 in)
Summary of Contents for XT1200Z(Z) 2010
