Xerox Phaser 8860, Service Manual

Page: 8 / 316

09/2007
viii Phaser 8860/8860MFP Service Manual
Moving the System
Initial Issue Introduction
Moving the System
WARNING
Parts of the system are hot. To avoid personal injury or damage to the system, allow the
ink to solidify. Run the shutdown procedure to park the Printhead and begin cooling the
system. Wait at least 30 minutes for the system to cool before moving or packing the
system.
• Allow the system to cool to avoid ink spills which can damage the system.
• Use the shutdown procedure from the Control Panel before moving the system.
• Never move the system if a Power Down Error-Head not Parked message is displayed.
Damage to the system can occur if the Printhead is not locked before shipment.
• Use the power switch to turn off the system, and unplug all cables and cords. Do not turn
off the system by pulling the power cord or using a power-strip with an on/off switch.
• For the 8860MFP, lock the scanhead shipping restraint before removing the scanner por-
tion for shippment. Moving the scanner with the scanhead unlocked can damage the
scanner.
Figure 1 Locking the Scanhead
• Always remove the document feeder and Scanner before shipping the system.
• The system is heavy and must be lifted by two people.
Figure 2 System Lifting Technique
• Always move the system separately from optional Trays 3 and 4.
When shipping the system, repack the system using the original packing material and boxes or
a Xerox repackaging kit. Instructions for repacking the system are included in the kit. If you do
not have all the original packaging, or are unable to repackage the system, contact your local
Xerox service representative
CAUTION
Failure to repackage the system properly for shipment can result in damage to the system.
Damage to the system caused by improper packaging is not covered by the Xerox warranty,
service agreement, or Total Satisfaction Guarantee.