Xerox Phaser 8860, Service Manual

Page: 132 / 316

09/2007
4-8 Phaser 8860/8860MFP Service Manual
REP 1.0.9, REP 1.0.11
Initial Issue Repairs and Adjustments
REP 1.0.9 Control Panel (8860MFP)
Parts List on PL 1.0
Removal
1. Open the Scanner.
2. Remove 2 (plastic, T-20) screws that secure the Control Panel to the Scanner.
Figure 1 Removing the 8860MFP Control Panel
3. Release the tab at each end of the Control Panel, then release the remaining 4 tabs along
the front edge to access the Control Panel connector.
4. Disconnect P/J19 and remove the Control Panel from the Scanner.
REP 1.0.11 Scanner Assembly (8860MFP)
Parts List on PL 1.0
Removal
CAUTION
Lock the Scanhead before removing the assembly. A utility for locking the Scanhead is pro-
vided in the Service Tools Menu. Power down the printer with the DADF closed.
1. Remove the DADF ( REP 1.0.15 ).
2. Place the Scanhead in the locked position for removal.
3. Disconnect the Scanner from the system.
Figure 1 Unlocking the Scanner Hinges
4. Release the hinge latches using a screwdriver or pen.
5. Slide the Scanner towards the back, and then lift to remove it from the printer.
Replacement
NOTE: Failure to adequately secure the Scanner cable connection to the Rear Panel can result
in sporadic Scanner errors. Seat the Scanner connector completely using the connector’s two
thumbscrews.