Xerox Phaser 8860, Service Manual

Page: 137 / 316

09/2007
4-13 Phaser 8860/8860MFP Service Manual
REP 1.1.7, REP 1.1.8
Repairs and Adjustments Initial Issue
REP 1.1.7 Exit Cover (8860)
Parts List on PL 1.1
Removal
1. Remove the Left Side Cover ( REP 1.1.9 ).
2. Remove the Right Side Cover ( REP 1.1.10 ).
3. Lift the Exit Cover from the chassis.
Figure 1 Removing the Exit Cover
Replacement
Lift the Upper Exit Guide slightly, and engage the pins on the Upper Exit Guide with the slots on
the Exit Cover before inserting the cover hinge pins into the pivot points in the printer frame.
REP 1.1.8 Ink Loader (8860)
Parts List on PL 1.1
Removal
CAUTION
Allow adequate time for the system to cool before servicing the Ink Loader.
1. Remove the Left Side Cover ( REP 1.1.9 ).
2. Remove the Right Side Cover ( REP 1.1.10 ).
3. Remove the Exit Cover ( REP 1.1.7 ).
4. Press the left and right sides of the Ink Loader inward, then lift to access the 2 connectors.
5. Disconnect the Ink Loader Power harness P/J5 from the Electronics Module.
6. Remove the Ink Loader harness from the retaining clip on the right side, and then discon-
nect the harness
P/J0150 from the Ink Loader to remove the Ink Loader.
Figure 1 Removing the Ink Loader
Replacement
The Ink Loader data harness comes from the side of the chassis and plugs directly into the Ink
Loader. After replacing the Ink Loader, reset the ink stick count, using the Hidden Service
Menu. Perform these steps while replacing the Ink Loader.
1. Secure the Ink Loader harness in the retainer clip provided on the Ink Loader, and con-
nect
P/J0150 .
2. Route the Ink Loader Power harness towards the left side and connect P/J5 .
3. Transfer the Ink Sticks to the replacement Ink Loader.