Xerox Phaser 8860, Service Manual

Page: 201 / 316

09/2007
4-77 Phaser 8860/8860MFP Service Manual
ADJ 1.15.1
Repairs and Adjustments Initial Issue
Figure 2 Scanning the Scanner Calibration Page
NOTE: Make sure the Scanner Calibration page is aligned correctly. If the page is mis-
aligned, the calibration procedure fails.
6. Close the document feeder.
7. Select the Document Glass Step from the menu, and then press Enter to scan the Scan-
ner Calibration page.
8. When the scan completes, check the Control Panel message:
• If the Control Panel indicates Success, select Continue, press Enter, and then con-
tinue with Step 9.
• If the Control Panel indicates Failure, select Continue, press Enter, and then repeat
Steps 5-7.
9. Remove the Scanner Calibration page from the platen.
10. Place the Scanner Calibration page in the DADF face up so the top edge enters first.
Adjust the paper guides so they fit against the page.
Figure 3 Loading the Scanner Calibration Page into the DADF
NOTE: Make sure the Scanner Calibration page is aligned correctly and the paper guides
are adjusted to fit against the paper. If the page is misaligned, the calibration procedure
fails.
11. Select Document Feeder Step from the menu, and then press Enter to scan the Calibra-
tion page.
12. When the scan completes, check the control panel message:
• If the Control Panel indicates Success, select Continue, press Enter, and calibration
procedure is complete.
• If the Control Panel indicates Failure, select Continue, press Enter, and then repeat
Steps 1 and 2 until a successful result is achieved.