Xerox Phaser 8860, Service Manual

Page: 23 / 316

09/2007
xxiii Phaser 8860/8860MFP Service Manual
System Specifications
Introduction Initial Issue
Figure 1 Minimum Clearances
Print Engine Specifications
8860MFP Scanner/DADF Specifications
Table 7 Print Engine Functional Specifications
Characteristic Specification
Printing process Solid-ink
Controller 500 MHz processor
Color medium Yellow, cyan, magenta, and black ink sticks, each shape-
coded. The system uses the subtractive color system to
produce the colors red, green, and blue
Color Management Automatic, Black & White,
Office: sRGB, Vivid Color, None,
Press: Commercial, Euroscale, SWOP
FPOT, Color Copy < 15 seconds per page/1st copy
subsequent copies at printer speed.
Memory 2 slots; minimum 256 MB, maximum 1 GB, PC133 DRAM
Fonts 137 PostScript 3
81 PCL5c
Warm-up time From Off (cold start): 12 minutes
From power saver: 4 minutes
Table 8 Scanner/DADF Functional Specifications
Characteristic Specification
Printing Process Print Engine
Scan to Capabilities Scan to Disk (mailbox) function
Scan to PC
Scan/Copy Process Flatbed platen and C-shape DADF paper path
Charge Coupled Device scanhead
RGB color pack
The scan controller provides 16 bit DMA interface for sending
image data through the scanner board to the image proces-
sor board in the electronics module.
Copies per Minute DADF: 20 ppm simplex, 10 ppm duplex
Memory 2 MB (1M x 16 SDRAM)
Image Buffer 32 MB SDRAM for Platen
128 MB SDRAM for DADF
Bit Depth Reading: 48 bits
Output: 24 bits
Optical Resolution 600 x 300 to 600 x 2400 dpi (FS x SS)
Output Resolution from Scan-
ner Always equals optical resolution
Calibration Time less than 2 seconds (performed prior to copier and scan
operations)
Power Saver Mode Scanner and DADF are switched OFF. Also, lamps automati-
cally turn off after 20 minutes.