Xerox Phaser 8860, Service Manual

Page: 157 / 316

09/2007
4-33 Phaser 8860/8860MFP Service Manual
REP 2.0.11 , REP 2.0.12
Repairs and Adjustments Initial Issue
Replace the KL-Clips on the outside grooves of the Drum Maintenance Camshaft, and perform
the Head Tilt Gear (
ADJ 4.13.1 ), and Process Drive Alignment ( ADJ 4.7.1 ) adjustments before
restoring system power.
REP 2.0.12 Stripper Carriage Assembly
Parts List on PL 2.0
Removal
NOTE: These steps describe Stripper Carriage removal for the 8860MFP. On 8860 models,
access the Stripper Carriage by removing the Control Panel ( REP 1.1.6 ). Afterwards, return to
this procedure and begin at Step 4.
1. Remove the Scanner Assembly and attached DADF ( REP 1.0.11 ).
2. Remove the Right Side Cover ( REP 1.0.21 ).
3. Remove the Output Tray ( REP 1.0.6 ).
4. Remove the Outer Duplex Guide ( REP 3.0.6 ).
5. Remove the Upper Duplex Guide ( REP 3.0.5 ).
6. Prop open the Exit Door.
7. Disconnect P/J250 from the I/O Board.
8. Remove 2 (plastic, T-20) screws that secure the I/O Board to the chassis. Slide the board
towards the rear to release it from the ground strap, and then downward to position it out
of the way.
9. Loosen 1 (plastic, T-20) screw that secures an I/O Board ground strap and the Transfix
Roller Shaft Restraint, then remove the restraint.