Xerox Phaser 8860, Service Manual

Page: 164 / 316

09/2007
4-40 Phaser 8860/8860MFP Service Manual
REP 2.0.16, REP 2.0.17
Initial Issue Repairs and Adjustments
10. Disconnect P/J860 from the I/O Board.
11. Feed the harness through the hole in the chassis near the front of the Drum Assembly
while sliding the plate out the Drum Maintenance drawer cavity.
Figure 2 Removing the Drum Maintenance Pivot Plate
Replacement
Lightly grease the metal plates on the underneath side of the Pivot Plate using a small amount
of Rheolube 768 grease (P/N 070E00890). Also check that the right end of the Pivot Plate
Shaft is in contact with the Ground Plate following installation of the Drum Fan. Perform the
Head Tilt Gear (
ADJ 4.13.1 ), and Process Drive Alignment ( ADJ 4.7.1 ) adjustments before
restoring system power
REP 2.0.17 Preheater and Deskew Assembly
Parts List on PL 2.0
Removal
1. Open the Front Door
2. Remove the Lower Inner Duplex Guide ( REP 3.0.2 ).
3. Remove the Inner Simplex Guide ( REP 3.0.1 ).
4. Release the lock on the back of the AC connector ( P/J0720 ) and unplug 2 connectors
from the Preheater.
Figure 1 Preheater Electrical Connections
5. Slide the latches in and forward to release the Preheater as shown in Figure 2 .