Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 320 / 503

Phaser 5400 Laser Printer Service Guide 291
RRP 5.3 Exit Roller Assembly
(See PL 6.1 Rear Cover Assembly With Fuser )
Removal
Warning: Switch off the power and disconnect the Power Cord.
1. Open the Rear Cover.
2. Remove the Rear Cover (RRP 1.9 Rear Cover).
3. Remove the four screws that secure the Lower Exit Chute Assembly. Remove the
assembly.
4. Remove the four screws that secure the Upper Exit Chute. Remove the chute.
5. Remove the E-ring that secures the right end of the Upper Exit Roller Assembly.
6. Release the three locking tabs and remove the Gear Z15 from Upper Exit Roller
Assembly.
7. Remove the left and right bearings from the Exit Roller.
8. Remove the two paper tabs from the shaft.
9. Move the Exit Roller Shaft to the left until the right end is free of the Rear Cover.
Remove the Exit Roller.
10. Remove the E-ring that secures the right end of the Lower Exit Roller Assembly.
11. Release the three locking tabs and remove the Gear Z22 from Lower Exit Roller
Assembly.
12. Remove the left and right bearings from the Exit Roller.
13. Move the Exit Roller Shaft to the left until the right end is free of the Rear Cover.
Remove the Exit Roller.
Figure 79 Lower Exit Chute