Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 132 / 503

Phaser 5400 Laser Printer Service Guide 103
RAP 35 Error Code: 0102 - DIMM 2
DIMM in slot J5 has failed at Power-Up.
Table 56 0102 - DIMM 2 Troubleshooting Procedure
Step Actions and Questions Yes No
1 PROCEDURE
1. Switch printer power OFF.
2. Remove the Left Side Cover [RRP 1.1, page 250 ].
3. Remove the DIMM installed in Slot 2 (J5).
4. Switch printer power ON.
Is the “0102 - DIMM 2” error message still
displayed on the Control Panel LCD?
Replace the
System
Controller
Board
[RRP 8.1,
page 305 ].
Go to
Step 2.
2
DIMM TEST
1. Switch printer power OFF.
2. Install the removed DIMM into Slot 1 (J4).
3. Switch printer power ON.
Is the “0101 - DIMM 1” error message displayed
on the Control Panel LCD?
Replace the
DIMM. Go to
Step 3.
3 DIMM RETEST / VERIFICATION
1. Switch printer power OFF.
2. Remove the DIMM from Slot 1 (J4) and reinstall it into
Slot 2 (J5).
3. Switch printer power on.
Is the “0102 - DIMM 2” error message still
displayed on the Control Panel LCD?
Replace the
System
Controller
Board
[RRP 8.1,
page 305 ].
Attribute the
problem due
to a poor
connection
of the DIMM
on the
System
Controller
Board.
4 SUSPECT COMPONENTS
The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one
at a time, until you isolate and solve the problem.
■
Print Engine Controller Board [RRP 8.5, page 310 ]
■
LVPS Power Supply [RRP 8.6, page 312 ]
■
Harness Assembly [PL 9.1, page 404 ]