Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 6 / 503

Phaser 5400 Laser Printer Service Guide v
Fuser Components
Warning: This printer uses heat and pressure to fuse the toner image
to a sheet of paper. The Fuser Assembly is very hot. Switch
off printer power and wait at least 30 minutes for the Fuser
to cool before you attempt to service the Fuser Assembly or
adjacent components.
Safety Components: Make sure covers and panels are in place and that all interlock
switches are all functioning correctly after you have completed a printer service call. If
you bypass, or cheat, an interlock switch during a service call, use extreme caution when
working on or around the printer.
Warning Labels: Throughout the printer, warning labels are displayed on potentially
dangerous components. When you service the printer, check to make certain that all
warning labels are in place.
Most importantly, read and obey all posted warning labels.
Warning: Turning the power off using the On/Off switch does not
de-energize the printer. You must remove the power cord to
disconnect the printer from the main power source. Keep the
power cord accessible for removal in case of an emergency.
Safety Instructions: Read all installation instructions carefully before you plug the
product into a power source.
Care of Product:
Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug:
■
If the power cord or plug is frayed or otherwise damaged,
■
If any liquid or foreign material is spilled into the case,
■
If the printer is exposed to any excess moisture,
■
If the printer is dropped or damaged,
■
If you suspect that the product needs servicing or repair, or
■
Whenever you clean the product.
Ground the product:
Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a properly
grounded outlet.