Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 91 / 503

62 Phaser 5400 Laser Printer Service Guide
7 BOTTOM PLATE INSPECTION
1. Remove Tray 1 and remove all paper.
2. Open the printer Top Cover, remove the Print
Cartridge and extend the MBF to the paper load
position.
3. Insert the Tray Assembly into the printer and observe
the bottom plate.
Is the bottom plate raised?
Go to
Step 8. Replace the
tray
assembly.
8
Tray 1 FEED ROLLER TEST
1. Close the MBF.
2. Reinstall the Print Cartridge.
3. Close the Top Cover.
4. Remove Tray 1.
5. Enter Diagnostics mode.
6. From the Main Menu, select Component Test / Main
Motor / press [4] to start test.
7. While the Main Motor is running, select Component
Test / Tray 1 Feed Sol / press [4] to test.
Note: It may be necessary to press [4] several times
to observe the rollers.
8. Observe the Tray 1 Feed Rollers.
Do the Feed Rollers rotate one complete
revolution?
Go to
Step 9. Go to
Step 10.
9 RETARD CHUTE ASSEMBLY INSPECTION
1. Remove the Retard Chute Assembly [RRP 3.1,
page 273 ].
2. Inspect the retard holder and retard arm for damage.
Is the Retard Chute Assembly OK?
Go to
RAP 55,
page 145 .
Go to
Step 10.
10 RETARD CHUTE / RETARD HOLDER
REPLACEMENT
Replace the Retard Chute Assembly [RRP 3.1,
page 273 ] or the Tray 1 Retard Holder Assembly
[RRP 2.11, page 272 ] as necessary.
Does the problem persist?
Go to
RAP 56,
page 147 .
Problem
solved.
11 SUSPECT COMPONENTS
The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one
at a time, until you isolate and solve the problem.
■
Wiring and connectors linking the components
Table 30 Error Code E2-1: Paper Jam Troubleshooting Procedure (cont'd.)
Step Actions and Questions Yes No