Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 269 / 503

240 Phaser 5400 Laser Printer Service Guide
Maintenance Kit Counter Reset
Procedure
The Control Panel informs the user when it is time to install a Maintenance Kit by
displaying “Maintenance Kit - Replace.” Printing is not inhibited. After a new BTR
and fuser are installed, the Maintenance Kit Counter must be manually reset.
Wordless reset instructions are included in the kit. The procedure below is provided
for when those instructions are unavailable.
Note: The Maintenance Kit Counter should only be reset when a
complete kit has been installed.
1. Make certain the printer is OFF.
2. Press and hold buttons [2] and [6] on the Control Panel while you switch ON
printer power. Continue holding until
*
IOT?
*
appears in the display
(approximately 20 seconds).
3. When the Control Display shows
*
IOT?
*
, release buttons [2] and [6], then press
and hold button [0] and [5]. You have 10 seconds to release [2] and [6] and press
[0] and [5]. Hold [0] and [5] until “Reset Complete Please Reboot” is displayed.
This message confirms the counter has been reset.
The Maintenance Kit is a customer purchased, Customer-Replaceable Unit (CRU).
The interval for replacement is 200K prints.
For Maintenance Kit part numbers, see Xerox Supplies and Accessories in the FRU
Parts Lists on
page 428 .
0 1 2 3
4 5 6 7
0 1 2 3
On Line Form Feed ! Fault Data
On Line Menu Up Item Up Value Up
4 5 6 7
Enter Menu Down Item Down Value Down
s5400-348
Xerox Phaser™ 5400
0 1 2 3
4 5 6 7
0 1 2 3
On Line Form Feed ! Fault Data
On Line Menu Up Item Up Value Up
4 5 6 7
Enter Menu Down Item Down Value Down
s5400-350
Xerox Phaser™ 5400
4
5
5