Xerox 5400N - Phaser B/W Laser Printer, Service Quick Reference Manual

Page: 288 / 503

Phaser 5400 Laser Printer Service Guide 259
RRP 2.1 Multi-sheet Bypass Feeder (MBF)
Assembly
(See PL 4.2 Paper Handler )
Removal
Warning: Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Open and extend the MBF Assembly to the paper load position.
3. Remove the screw that secures the cover to the left side of the MBF Assembly.
4. To release the locking tab, push in slightly on the left front of the cover and rotate
the cover clockwise to remove with the left hand, while pulling the rear ‘piece’
toward you to release the alignment pin with the right hand.
5. Release the harness from the underside of the cover.
6. Disconnect the in-line connector P/J121.
7. Critical : Push the MBF into the home position.
8. Push down and hold onto the left tray stop, pull out to remove.
9. Push down on the right tray stop, pull out to remove.
10. Extend the MBF Assembly until it stops.
11. Lift the front of the paper handler 1.5 to 2 in. (38 to 51 mm) and remove the MBF
Assembly.
Figure 45 MBF Paper Handler Assembly