Setup Parameters
5 - 38
Modified: 9/17/08
MedWeld 4000 Operator’s Guide
M-032116 Programs #T03300, #T02300 and #T02400
Quick Reference to Setup Parameters (T02306)
The following list shows the default value for each parameter in
program #T02306, as programmed at the factory:
INVALID SEQUENCE SELECTED (FAULT)
WELD INITIATE NOT PRESENT (ALERT)
CONTROL STOP (FAULT)
STEPPER APPROACHING MAX (ALERT)
END OF STEPPER (FAULT)
HIGH CURRENT LIMIT FAULT (FAULT)
LOW CURRENT LIMIT FAULT (FAULT)
CONTROL FAILED TO FIRE (NONE)
EXTENDED WELD (FAULT)
ISO CNTR OFF WHEN NEEDED (FAULT)
ISO CNTR ERR-BRKR TRIPPED (FAULT)
NO ZERO CROSSING SYNC (FAULT)
LOW BATTERY (ALERT)
HIGH C-FACTOR LIMIT (ALERT)
LOW C-FACTOR LIMIT (ALERT)
SYSTEM COOLING (FAULT)
HEAT CYCLE LIMIT (FAULT)
WELD INTERRUPTION (FAULT)
I/O (FAULT)
STAGE 2 / WELD PROCEED (FAULT)
PRESSURE SWITCH (FAULT)
RETRACT PILOT (FAULT)
ISO CONTACTOR NOT ENABLED (FAULT)
CONTROL IN NO WELD: (ALERT)
INVERTER SERIAL COMM ERROR(FAULT)
INITIATION ON POWER-UP (FAULT)
CONTACTOR SHORT(FAULT)
ANALOG NOT WITHIN WINDOW (FAULT)
PRESSURE NOT AVAILABLE (FAULT)
LOW POWER LINE (ALERT)
SOFT OVERCURRENT (ALERT)
CURRENT REGULATION (ALERT)
SEC CURRENT SENSOR (ALERT)
WELDING TRANSFORMER (FAULT)
DC BUS OVER VOLTAGE (FAULT)
INVERTER BUS (FAULT)
CAPACITOR DISCHARGE (FAULT)
CAPACITOR CHARGING (FAULT)
CHARGE/DISCHARGE DUTY CYCLE (FAULT)
INVERTER ISO CONTACTOR OFF (FAULT)
INVERTER OVER TEMP (FAULT)
OUTPUT GROUND (FAULT)
HARD OVERCURRENT(FAULT)
LOW VOLTAGE (FAULT)
TFMR DUTY CYCLE(FAULT)