Winterthur Gas X35-B, Maintenance Manual, Page: 79 / 547

Maintenance
0380 − 1/A1
Winterthur Gas & Diesel Ltd.
7/ 9
Group Component Applicable Maintenance Intervals (Op. h)
6
6420 − 1 Scavenge air
receiver
− Do a check and clean the flaps 4000 to 6000
− Clean the receiver 4000 to 6000
− Make sure that the water drains and holes are not
blocked
1500 to 3000
Turbocharger − Wash-clean of blower during operation (refer to the
manufacturer’s
documentation)
− Wash-clean or dry clean the turbine during
operation
(refer to the
manufacturer’s
documentation)
Air filter − Do a check of the filter half yearly
− Clean the oil filter at a n p increase of 50%
compared to the shop test value at same engine
load
(refer to the Operation Manual 6510 − 1)
as necessary
6545 − 1 Auxiliary blower − Clean impeller and casing 24 000 to 36 000
− Replace ball-bearing 24 000 to 36 000
6606 − 1 Scavenge air
cooler
− Clean the scavenge air cooler (air side) during
operation weekly at first, then later if a
n p
(pressure decrease through the SAC) increases
compared to the shop test value at same engine
load
(refer to the Operation Manual 6606 − 1)
as necessary
− Do a check through the sight glass of the
condensate collector
(refer to the Operation Manual 8345 − 1)
daily
− Make sure that the condensate collector is not
blocked
(refer to the Operation Manual 8345 − 1)
1500 to 3000
− Do a check of the scavenge air cooler sealing quarterly
− Bleed daily
− Remove scavenge air cooler for general overhaul as necessary
2020
Inspection and Overhaul Intervals (Guidelines)