Winterthur Gas X35-B, Maintenance Manual

Page: 237 / 547

Maintenance
3303 − 2/A1
Winterthur Gas & Diesel Ltd.
5/ 6
14) Move the manual ratchet (H1, Fig. 5 ) to
the position shown.
15) Attach the manual ratchet (H1) to the
bearing cover.
16) Operate the turning gear to move the
crank to TDC.
17) Make sure that the bearing shell is
clean.
18) Put oil on the bearing shell as follows:
a) If you start the engine immediately
after completion of this procedure,
use only bearing oil.
b) If the engine has stopped for
some days, use a mixture of
high-viscosity oil (steam engine
cylinder oil, ISO VG 1000/1500)
and bearing oil. The ratio is two
thirds ISO VG 1000/1500 to one
third bearing oil.
Note: A list of suppliers for ISO VG
1000/1500 high viscosity oils is
given in Table 1 .
19) Operate the the manual ratchets (H1,
H2, Fig. 6 ) to fully lift the bearing cover.
Make sure that the elastic bolts (1) align
with the holes in the connecting rod.
2017
Bottom End Bearing − Removal, Inspection and Installation
WCH00573
H1
H2
Fig.5
H1
1
Fig. 6
H2
2
3
94572G
94572G
94572G
94572G