Triton RL5000, Service Manual

Page: 83 / 173

66
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
R
EPLACING THE
D
ISPLAY
A
SSEMBLY
Tools:
1 - #2 Phillips Screwdriver
The display assembly is located in the control panel and is comprised of two (2)
replaceable components, the complete LCD assembly and the LCD backlight in-
verter. The LCD assembly consists of the LCD (Liquid Crystal Display) panel and
a glass shield that is sealed over the face of the LCD panel. The LCD backlight
inverter is mounted in the display assembly bracket.
R
EMOVING THE
D
ISPLAY
1. "Shutdown the Terminal" from Management Functions.
2. Unlock and open the control pan el.
3. Push the AC pow er ON/OFF switch to the OFF(0) position.
4. Remove the mainboard. (Refer to the procedures for R
EMOVING THE
M
AINBOARD
as necessary).
5. Remove the docking board. (Refer to the procedures for R
EMOVING THE
D
OCK
-
ING
B
OARD
as necessary).
6. Refer to Figure 3-45. Remove the four (4) Phillips head screws that secure
the display to the control panel.
7. Refer to Figures 3-45 and 3-46. Carefully slide the display assembly out from
under the printer assembly and then up and out of the control panel. If the
gasket seal for the glass display shield comes loose from the control panel or
is damaged, it will need to be replaced.
Figure 3-46. Location of the retention sock-
ets for the rear display position locator legs
and the seal for the display assembly.
Control panel seal for the
the display assembly
Printer
Figure 3-45. Location of the display assembly
mounting points in the control panel and the dis-
play position locator legs.
Display Position
Locator Legs
Printer