Triton RL5000, Service Manual

Page: 89 / 173

72
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
I
NSTALLING THE
P
RINTER
C
ONTROLLER
PCB
1. Refer to Figures 3-53 and 3-54 (XScale only). Verify the (3) jumpers and (2)
DIP switches on the printer controller PCB con form with the standard XScale
confi guration settings.
2. Refer to Figure 3-50 (XScale version) or Figure 3-51 (X2 version). Align
the printer controller PCB with the four standoffs on the print er assembly
mounting plate and secure it with the four (4) screws that were re moved
ear li er.
3. Refer to Figure 3-50 (XScale version) or Figure 3-51 (X2 version) and Fig-
ure 3-52. Reconnect all ca bles to the print er controller PCB.
4. Push the AC pow er ON/OFF switch to the ON(I) po si tion.
5. Close and lock the control pan el.
6. Verify that the ATM op er ates cor rect ly before plac ing it into ser vice.
Jumper Configuration Table
Product JP1 JP3 JP4
ALL Shorted Pins 1 - 2 Pins 1 - 2
* All other jumpers are left open.
1 2 3 4 5 6 7 8 9 10
ON
1 2 3 4 5 6 7 8 9 10
ON
DIP Switch 1
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
DIP Switch 2
Switch Position ON OFF
DIP Switch 1 6-7 1, 8-10
DIP Switch 2 1, 3 2, 4-8
Figure 3-54. Printer control board DIP switch settings.
Standard XScale Printer Controller
PCB Jumper and DIP Switch Settings
Figure 3-53. Location of the XScale DIP
switches, jumpers, and jumper settings.
ON
ON
OFF
OFF
XScale Version
DIP Switch 1 DIP Switch 2
Jumpers
3 & 4
Jumper
1
CN1 Power (DC)
CN2 Printer Mechanism Thermal Print Head
CN3 Autocutter
CN4 Printer Mechanism Paper Feed Motor
CN5 Paper Out / Head Up Detector
CN6 * Serial Communications (* XScale only)
CN6 * Not Used (* X2 only)
CN8 * USB Communications (* X2 only)
CN9 * Presenter PCB (* X2 only)
CN10 * Low Paper / Manual Paper Feed (* X2 only)
Figure 3-52. Location of cable connections the
printer controller PCB
Printer Controller PCB Cable Connections