Triton RL5000, Service Manual

Page: 123 / 173

106
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
T5 EPP LED S
TATUS
T
ABLE
R
EPLACING THE
T5 EPP B
ATTERY
Refer to Figure 3-93. Always plug in a spare bat-
tery before removing the old battery.
Refer to Figure 3-93. Location of
battery and spare connector
Red Green Meaning Comment
On On The EPP contains no valid Field
Loader OR The EPP software is
initializing.
The T5 EPP needs repair. Firmware load
cannot be done. Indicated for a while af-
ter a reset (power up).
Off On The Field Loader is active / idle.
Flashing
Irregular On Field Loader is active / External
communication.
The LED fl ashes when a command is re-
ceived or when a response is returned.
Off Flashing
2 Hz Initialization concluded. The application is waiting for the fi rst
command and the removal switch is In-
active, RSA Certifi cates are loaded.
Off Flashing
1 Hz Initialization concluded. The application is waiting for the fi rst
command and the removal switch is Ac-
tive, RSA Certifi cates are loaded.
Flashing
2 Hz Flashing
2 Hz Initialization concluded. The application is waiting for the fi rst
command. One or more RSA certifi cates
are missing. Removal switch inactive.
Flashing
2 Hz Flashing
1 Hz Initialization concluded. The application is waiting for the fi rst
command. One or more RSA certifi cates
are missing. Removal switch Active.
Off Off The EPP application is ready, af-
ter receiving fi rst command.
Power must be on.
On Off The Keyboard is in “PIN entry”,
"Key Entry” or “Password entry”
mode.
Secure mode
Flashing
2 Hz Off The Keyboard is in “Cleartext
entry” mode.
Unsecure mode
Flashing
Irregular Off Application is active / External
communication.
The LED fl ashes when a command is re-
ceived or when a response is returned.
Figure 3-92. PCI T5 Sagem EPP LED Status Table
**CAUTION**
The T5 EPP will be permanently damaged
if a spare battery is not plugged in before
removing the old battery.