Triton RL5000, Service Manual

Page: 69 / 173

52
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
3. Plug in all external DC power connections to the power sup ply assembly.
4. Connect the AC input and out puts, e.g., topper, to the power supply assem-
bly.
5. Push the main AC pow er ON/OFF switch to the ON(I) po si tion.
6. Ver
i fy all of the "power present" LED indicators on the face of the power sup-
ply assembly turn on (refer to Figure 3-23).
7. Close and lock the control panel.
8. Verify prop
er op er a tion pri or to put ting the ATM in op er a tion.
F
USES
There are three (3) fuses that protect the pow er
supply and any connected DC components. The fi rst
is an external in-line 6.3 AMP 250 VOLT fuse (re-
placeable). It is lo cat ed at the top of the black AC
power strip on the left side of the pow er sup ply (See
Fig ure 3-22). The other two (2) are an internal 5
AMP 250 VOLT fuse (soldered in) and a 2.5 AMP 250
VOLT fuse (replaceable) located inside the power
supply assembly (see Figure 3-17).
P
OWER
S
UPPLY
D
IAGNOSTIC
S
TATUS AND
T
ESTING
Refer to the Figure 3-23. There are fi ve (5) "power present" LED indicators just
above the external DC output connectors. They effectively detect DC outputs
from the primary quad output AC-DC power supply (+5v, -12v, +12v, +24v) and
the secondary single output power supply (+12v fl oat).
Figure 3-22. Pop up the fuse
holder to gain access to the 6.3
AMP 250 Volt fuse.
Figure 3-23. DC Output LED indicators
+5v
-12v
+12v
+24v
+12v Float
(1) 10-pin DC output
connector used for
the TDM, MiniMech,
SDD, and NMD dis-
pensers
(6) 8-pin DC output
connectors used for
the docking board
and the printer